...
Plug the adapter the adapter in the AC power outlet and wait until the Power and Wireless lights indicators are illuminated continuously.
...
Confirm the Wi-Fi to Ethernet adapter operation
Ensure that the PowerRE, Wireless and RE lights Power indicators are illuminated continuously, and that the wireless signal strength is sufficient (ie. 2 or more signal strength lights indicators are illuminated).
...
Nb. The Ethernet light indicator will also illuminate after the Wi-Fi adapter has been connected to the Flow Gateway via an Ethernet cable and the Flow Gateway has been powered on.
...
If there are any issues with the configuration of the Wi-Fi to Ethernet adapter it can be factory reset by following the below procedure, then repeating the setup from step 1.
With the Range Extender Wi-Fi to Ethernet adapter powered on, use a small screw driver (or pen, pin, paper clip etc.) to press and hold the RESET button (small hole adjacent to the Ethernet port) until the entire ring of blue lights illuminate briefly (approximately 8 seconds).
Release the RESET button and wait the Range Extender Wi-Fi to Ethernet adapter to reboot to its factory default settings.