...
Email support@flowcoffee.co.nz
Safety
...
instructions
The Flow Gateway must be installed by a technician with the appropriate levels of certification to perform work inside of a commercial espresso machine.
The maximum ambient temperature that the Flow Gateway is designed to operate in is 40°C (104°F). Ensure it is installed in a location where the ambient temperature does not exceed this.
Do not open the Flow Gateway, there are no serviceable parts inside. For all hardware faults return the Flow Gateway to a Flow Coffee authorised distributor.
Mounting requirements
Locate the Flow Gateway in a location that will not be affected by excessive heat, and where it will not come into direct contact with water or steam.
If the Flow Gateway is located where it may be disturbed, or if it is installed on the a wall or underside of a counter, secure the Flow Gateway using high strength double sided foam tape (eg. 3M VHB Double Sided Foam Adhesive). Remove the rubber feet from the bottom of the Flow Gateway before securing with high strength double sided foam tape.
If the Flow Gateway is wall mounted, it is only suitable for mounting at heights of less than 2 metres above floor level.
The Flow Gateway is not suitable for mounting on the underside of overhead kitchen cabinets (where it may be exposed to steam or excessive heat from equipment on the counter top below it).
...
2. Mount the Flow Gateway
Mount Locate the Flow device Gateway near the espresso machine in a location that is will not likely to be disturbed or affected by heat / water / excessive heat, and where it will not come into direct contact with water or steam (usually under the counter is the most appropriate location). Ensure the chosen location is in reach of the flow meter cable, AC power outlets, and if applicable Ethernet outlet.
Mount If the Flow Gateway is located where it may be disturbed, or if it is installed on the a wall or underside of a counter, secure the Flow Gateway using high strength double sided foam tape (eg. 3M VHB Double Sided Foam Adhesive). Remove the rubber feet from the bottom of the Flow Gateway before securing with high strength double sided foam tape.
3. Route the flow meter cable(s) to the Flow Gateway and secure the cable
...